Enables unit to mist through two nozzle circuits. Both zones may be set to the same mist schedule or to different schedules. Remote control may be set to operate both or either of the zones.

The MistAway Gen 1.3 Zone Kit is manufactured by MistAway and is a optional accessory that can be installed onto a Gen 1.3 MistAway Mosquito Misting System, enabling the unit to mist through double the amount of nozzles than originally packaged.

Tools Needed

To install a MistAway Gen 1.3 Zone Kit, you will need a crescent wrench and a screwdriver for disassembly and reassembly of the Gen 1.3 misting unit.

How to Use

• Step 1: Disconnect power to the unit. The kit wil be recognized by the controller after the install when it is rebooted.
• Step 2:Secure the Zone Kit to the chassis front shroud screw and connect tubing as shown.
• Step 3: Push the Zone Kit Wire Harness Adaptor through the acces port then insert the wire harness adaptor to the back of the controller.
• Step 4:Power on the unit and then it should be recognized and you can begin to set up nozzles per zone.

Where to Use

The MistAway Gen 1.3 Zone Kit is an optional item that is used to double the amount of nozzles to be used in your nozzle circuit setup thus giving you more misting coverage around your property.

When to Use

The Gen 1.3 zone kit should be installed when you prefer to double the amount of nozzles to use for your misting system to get better coverage of an area.

Safety Information

The product is safe to use and install when done so according to MistAway directions.

Special Considerations

This is an optional item that does not need to be installed unless you want to double the amount of nozzles for your system.