Mosquito Misting System Ball & Spring (100pk)

The Ball and Spring is a dependable replacement tool for the nozzle balls and spring valves of your Mosquito Misting System that need to be replaced.

When one or more nozzles are excessively dripping after misting, it may be time to replace them with these replacement balls and springs. For ease of convenience, this tool comes in a pack of 100 to keep your misting system in good condition and continue effectively controlling mosquitoes.

Mosquito Misting System Ball and Spring is an easy-to-use replacement tool for rebuilding a nozzle that is either dripping or clogged.

Tools Needed

To use the Ball and Spring, you only need a pair of pliers and a paper clip to help you pull off and replace the old ball and spring valves and tighten the new ones.

How to Use

• Step 1: Take the nozzle tips off your nozzles and unscrew the tip. 
• Step 2: Once the tip is screwed off, use a paper clip to push out the ball and spring.
• Step 3: Take one of the new ball and spring pieces and place it in the spot where the ball and spring were.
• Step 4: Screw the nozzle back together and attach it back to your Mosquito Misting System.
• Step 5: Repeat until all nozzle balls and springs have been replaced.

Where to Use

These Nozzle Ball and Springs should be used to replace all old balls and springs on the nozzles you have set up throughout your mosquito misting system.

When to Use

The ball and spring should be replaced at least once a year (if needed) before mosquito season arrives so they are ready to perform without issue.

Safety Information

Nozzle filters are safe to use around children and pets when installed according to the product manual instructions. Always wear the proper personal protective equipment (PPE) when installing this product. 

However, they are small and can be swallowed, so keep them away from pets and children.

Special Considerations

When replacing the ball and spring, you may also need to replace the filter.