This B&G Retainer Ring is manufactured by B&G Equipment Company and is specifically sold for use as a specialty part for B&G sprayers with the Extenda-Ban Valve. The B&G SRetainer Ring fits at the very tip of the extension wand and is necessary for holding all the Multeejet tip assembly parts in place (Multeejet CC tip, Viton gasket etc.) If your extension wand is experiencing a leak or the retainer tip is loose and wobbly, a replacement can fix the issue so your wand works like new.

Tools Needed

To use the B&G Retainer Ring, you will need a B&G Sprayer with an Extenda-Ban Valve extension wand and two adjustable crescent wrenches..

How to Use

• Step 1: Following the manufacturer instructions, detach the valve and extension from the hose. Carefully remove the mesh strainer and squeeze the trigger to drain all the liquid from the valve.
• Step 2: Remove the tip and nozzle assembly from the end of the extension. Twist off the retainer ring and then replace with the new retainer ring.
• Step 3: Reassembly the valve and wand assembly back on the sprayer, making sure to tighten all parts for they are secure. Test the sprayer out to make sure it sprays properly.

Where to Use

The B&G Retainer Ring is used primarily for B&G Sprayers with the extenda-ban valve. The retainer ring sits at the very tip of the extension wand and is instrumental in holding all the tip assembly parts in place.

When to Use

Use the B&G Retainer Ring to repair your B&G Sprayer when your extension wand is experiencing a leak the retainer ring looks worn or loose.

Safety Information

The product is safe to use when applied according to the label directions. Keep out of reach of pets or small children.

Special Considerations

This part is specifically for the Extenda-Ban Valve model of B&G sprayers. It will not fit with the Ban-Drip valve or XR valve.