B&G Plunger Rod PF-273

This B&G Plunger Rod is manufactured by B&G Equipment Company and is a replacement part that is essential in maintaining the pump assembly for 2-Gallon B&G sprayers. The B&G Plunger Rod connects directly to the Pump cap. If your 2-gallon sprayer's pump assembly is not pumping properly or there is a pressure issue, you may need to replace the plunger rod to get the pump working like normal again.

Tools Needed

To use the B&G Plunger Rod, you will need a B&G Sprayer with an Extenda-Ban Valve extension wand and two adjustable crescent wrenches.

How to Use

• Step 1: Take the Pump Assembly out of the tank
• Step 2: Disassemble the Pump assembly by removing the handle, Pump Lock Spring. You will then see the pump cap and the Plunger Rod directly connected to it. Remove the old plunger rod and replace with the new part.
• Step 3: Reassemble the pump assembly and put it back in the tank then test the product out to make sure that the tank ins pressurizing properly.

Where to Use

The B&G Plunger Rod is used for the 2-gallon sprayer. It connects directly to the pump cap.

When to Use

Use the B&G Plunger Rod to repair your B&G Sprayer when your sprayer pump is not pressurizing air properly.

Safety Information

The product is safe to use when applied according to the label directions. Keep out of reach of pets or small children.

Special Considerations

This product is specifically for the 2 Gallon Sprayer and will not fit the 1/2 gal, 3 gal or one gal sprayers. Make sure when you order it you are ordering the right part for your sprayer.