VT-617 Lock Screw by B&G Equipment Company is specifically sold for use as a replacement part for B&G Versatool Valve. Part of the valve trigger assembly on the B&G Versatool Valve. If your B&G Versatool's valve trigger is loose or not working properly, some parts may need to be replaced on it, including the lock screw.

Tools Needed

To use the VT-617 Lock Screw, you will need the B&G Versatool. You will also need an adjustable wrench.

How to Use

• Step 1: Following the manufacturer instructions for details and using an adjustable wrench, undo the trigger valve assembly, making sure to keep all the small nuts, screws and springs in a safe spot.
• Step 2: Remove the VT-617 Lock Screw and then replace with the VT-617 Lock Screw and make sure it is secured tightly to the valve trigger with the help of the hex nuts.
• Step 3: Reassemble the Versatool, making sure to tighten all parts so they are secure and then test the injector out to make sure it is working properly and there are no issues.

Where to Use

The VT-617 Lock Screw is used primarily for Versatool termite application tools.

When to Use

Replace the VT-617 Lock Screw when your Versatool trigger valve is not working properly or is leaking where trigger attaches to the valve.

Safety Information

The product is safe to use when applied according to the label directions. Keep the part out of reach of pets or small children.

Special Considerations

This part is specifically for the Versatool Termite application tool. It would be wise when replacing the lock screw to also replace the trigger lock, spring and rod screw since all of these start to rust and wear over time.