Bird B Gone Bird Chase Super Sonic Control Unit

Bird B Gone Bird Chase Super Sonic Control Unit, manufactured by Bird B Gone, is a high-tech sonic bird repeller that utilizes natural bird distress calls and predator cries to effectively scare away pest birds from large open spaces.

The device broadcasts distress and predator calls from over 24 different species, which helps to target a wide range of pest bird species. The diversity in calls likely helps prevent birds from becoming accustomed to a single type of sound. This flexibility lets users adjust when and how often the sounds are played, helping to optimize effectiveness. The system’s ability to run for about 2 minutes every 10 minutes is designed to continuously disturb the birds without overwhelming them.

Bird B Gone Bird Chase Super Sonic Control Unit is a well-crafted UV-protected and weatherproof bird repellent system that covers up to 1 acre. You also have the option to add additional speakers to extend this coverage up to 5 acres. This makes it ideal for larger open spaces or commercial properties with bird issues.

Tools Needed

The Control Box has two screw hole mounts on the back of the box. When mounting to a post, side of a building or other surface, use at least 1-1/2” long screws. Be sure to leave at least 3/8” to 1/2” of the screw exposed so that the control box can be easily hung and secured to the surface.

How to Use

• Step 1: Remove contents from the box. 
• Step 2: To access the Control Box located on the front of the unit, open the clear weatherproof cover by pressing down on the gray tabs with both thumbs while lifting up the middle tab.
• Step 3: Ensure that the Power Switch is in the “OFF” position.
• Step 4: Adjust the Volume Control to the "MIN" position by turning the volume dial counterclockwise to the lowest position.
• Step 5: Plug the AC Adaptor into the 110v Power Source. For 220v, use adaptor purchased separately. AC ADAPTOR MUST BE PROTECTED. DO NOT LEAVE IT EXPOSED TO THE ELEMENTS, DO NOT USE AN EXTENSION CORD. Plug it into an indoor or protected receptacle.
• Step 6: Find the Power Jack on the side of the operating unit (labeled POWER INPUT). Connect the power cord to the POWER INPUT jack.
• Step 7: Flip the Power Switch to the "ON" position. The red Power Light will indicate that the unit is powered on and ready for programming. The LED display will show icons for Sun (daytime), Moon (nighttime), and Sound.
• Step 8: If all components in step 7 are functioning properly, proceed to program the unit.

How to Program

• Step 1: Make sure the unit is in the “ON” position and the volume control is turned down to “MIN.”
• Step 2: The “SELECT” button will allow you to program the unit for: Daytime (the system will only play when the sensor detects sunlight), Nightime only (the system will only play when the sensor detects no sunlight), or All The Time (the system will play at all times, regardless of sunlight). 
• Step 3: After you choose your desired mode of time, Push the “SET” button.
• Step 4: The “MODE” button will allow you to program the unit for your target bird. The General Mode can be used for other species not listed. Push the “MODE” button until you see your desired bird on the display. When you are ready to select the desired bird, push the “SET” button. Pigeon – 1, Starling – 2, Woodpecker – 3, Grackle – 4, Crow – 5, Gull – 6, General – 7, and Goose – 8. 
• Step 5: Turn the Volume Control up slowly. You will hear the sounds emitting from the speaker. Adjust the control to the desired volume.
• Step 6: Close the Weatherproof Cover once you have finished programming. Be sure it is completely closed by snapping tightly.

Where to Use

Place the Bird B Gone Bird Chase Super Sonic Control Unit where pest birds gather most often: on rooftops, warehouses, semi-enclosed areas, open fields, storage facilities, backyards, courtyards, loading docks, gardens, patios, parks, golf courses, and pool areas.

When to Use

Any time pest birds are becoming a problem is the right time to use this unit. 

Safety Information

Bird B Gone Bird Chase Super Sonic Control Unit is safe to use around children and pets when installed according to the product manual instructions. Always wear the proper personal protective equipment (PPE) when handling and installing this product.

Special Considerations

Be sure that nothing is blocking or obstructing the light sensor. For Nighttime Mode, be sure that no “bright lights” are shining on the system, causing it to not play.

For Daytime Mode, be sure to place unit in direct sunlight. Any shadows or shade will cause the unit to pause until direct sunlight is detected.