The B&G Pivot Bolt 34514 is manufactured by B&G Equipment and it is a replacement piece of hardware for the B&G Robco Termite Tool. The B&G Pivot Bolt is to be installed on the QCG or Quick-Change Gun or the SRG and helps to hold the trigger piece in place on the gun. Over time, this part can suffer from general wear and tear from overuse and will need to be replaced. Purchase the Pivot Bolt to get your QCG or SRG gun working like new.

Tools Needed

To install the B&G Pivot Bolt you will need the QCG or SRG gun on the B&G Termite Tool, gloves and an adjustable wrench.

How to Use

• Step 1: Before starting, it is important to flush out any chemicals that could be left in the unit. To flush out the unit, simply add clean water and triple rinse. Once the unit is clean, you will need a clean working area preferably a table to dismantle the unit due to the many small parts.
• Step 2: Using the wrench, disassemble the Pivot bolt on the QCG gun by undoing the Pivot Bolt Nut and washer. You can then replace with the new pivot bolt and tighten using the nut and washer to secure it in place.
• Step 3: Reassemble the Robco Termite QCG gun, and then test out the gun by adding water to the unit and spraying to ensure there are no leaks.

Where to Use

The B&G Pivot Bolt is used in the B&G Robco Termite Tool and is part of the Quick-Change Gun assembly. The Robco Termite Tool is used primarily for sub slab injections such as on a driveway.

When to Use

The B&G Pivot Bolt will need to be replaced when it becomes damaged or worn.

Safety Information

Be sure to wear gloves when handling parts, as there may be residue from chemicals or buildup on the parts. Be sure to properly drain and clean the parts of the tool before performing maintenance. Keep the parts out of reach of pets and children.

Special Considerations

When replacing the parts to the B&G SRG and QCG guns refer to the manual which contains the diagram of various parts that may need regular replacement.

*We do not accept returns on equipment or electronics, all sales are final. We do this to ensure that the products we send out are brand new, never opened, and fully operational for our customers to ensure the packages are covered by their respected manufacturer's warranties.