The Vector glue boards are replacement boards for use in the Vector Classic and the Vector Plasma fly lights. These boards are easy to replace and have a large surface area for trapping flying pests like mosquitos, gnats, moths, and flies.

Tools Needed:

You don't need any other tools to replace the glue boards. Be sure to unplug the light and discharge any static before replacing the glue board.

How to Use:

• Step 1:  Unplug the device and discharge any built up static before handling the inner components of the light.
• Step 2: Remove the soiled glue board from the inside of the light and dispose of it. Wipe away any leftover debris or dust in the light.
• Step 3:  Peel off the wax paper covering the glue on the new board and place it inside the light, forming it to fit properly.

Where to Use:

Use this product in the Vector Classic and Vector Plasma insect lights. Be sure to read any manufacturer's instructions to ensure this glue board is a proper fit for the device.

When to Use:

Use this glue board when the older one is 70% covered or more, or if there is dirt and debris stuck to the glue. This would cause the board to be less effective.

Safety Information:

When replacing the glue boards be sure to observe proper electrical safety. While replacement should be clean and simple, it may be helpful to wear gloves.

Special Considerations:

This product is made for Vector Classic and Vector Plasma insect light traps, and may not fit properly in other systems. Be sure to research your device before purchase to ensure a proper fit. This product may need to be replaced more often in dry and dusty areas as dust and dirt can stick to the glue making it less effective.