Riser Stabilizer (10 pack)

The Riser Stabilizers are sturdy, well made stakes that are designed to fit the nozzles of your mosquito misting system.

Each stake will fit the nozzles inside of them, allowing easy access to the hose attachments which makes stringing the tubing easy and efficient.

Tools Needed

The stake can be easily pressed into the ground by foot, or you could use a shovel to clear the dirt and place the stake in.

How to Use

• Step 1: Measure out the area and plan where you want to place each nozzle, making sure you have an adequate amount of housing to achieve this.
• Step 2: Fit the spray nozzles into each stake in the fitted grooves, and press them into the ground in the desired areas.
• Step 3: Run your tubing along the path of the stakes. Cut the tubing where they intersect with the stakes and attach each end to the hose fittings on the nozzles.

Where to Use

Use the Riser Stabilizers around your property where you want to apply your misting nozzles. These stakes cannot be used on concrete or in wood, and may not stay in place well if driven into hard, dry ground.

When to Use

Use these stabilizers when you are setting up your permanent misting system. These stakes will stay in place until removed, so they work well to establish a good misting radius for permanent or long term use.

Safety Information

These products are safe to use. They may not stay in place well if driven into hard or dry earth, so it may be necessary to wet the location to soften the earth before placement.

Special Considerations

These Riser Stabilizers work with most mist nozzle sprayers, but it may be helpful to get proper measurements of your nozzles to ensure a proper fit.