The Hypro 5210c Piston Pump is manufactured by Hypro and is a necessary component for pesticide spraying rigs to deliver a pressurized spray of liquids for pest control and vegetation management applictions.

This Pump Features a max flow of 10 gpm and a max pressure of 400 psi. A max speed of 600 rpm and a solid shaft, bi-rotational Cast iron body and cylinder heads Leather cups. If your piston pump has malfunctioned, this replacement piston pump will get your spraying rig back to optimum performance.

Tools Needed

To use the Hypro 5210c Piston Pump you will need to install it onto a pesticide spraying rig. For this, you will need a base plate (sold separately), two Lovejoy couplets and a pressure regulator, screwdriver, socket wrench, allen wrench, a claw hammer. You will also need a strainer to catch any debris. There are specialty tools (listed in owner's manual) that are optional.

How to Use

• Step 1: Following the manufacturer instructions, remove the old piston pump from your spraying rig and replace with the Hypro 5210 Piston Pump. The Pump hooks up to the gas engine via 2 Lovejoy couplets and you will need to mount it on a base plate which will hold it onto the frame then configure plumbing.
• Step 2: Prime the pump by making sure all connections are tight and do not leak air. Also, make sure the strainer line is free of debris. If the pump does not self-prime, disconnect the suction hose, fill it with water and reconnect it to the liquid source. A squirt of oil into the pump ports will help to prime by sealing clearances.
• Step 3: After every application, flush the pump with a cleaning solution that will neutralize the liquid pump then flush it with a 50-50 solution of car antifreeze and water to prevent corrosion. Turn the shaft several times to drawl the protective liquid through the pump to coat the entire inner surface and then drain the pump and plug the ports to keep air out.

Where to Use

The Hypro 5210c Piston Pump is a replacement part for a variety of industrial uses. We use them primarily in pesticide spraying rigs for pressurizing the sprayer liquid during applications.

When to Use

Use the piston pump as part of a pesticide skid sprayer for tree spraying, turf application, herbicide application, termite work and perimeter spraying around structures.

Safety Information

Always use the proper PPE when operating or performing maintenance to the piston pump (safety mask, gloves, protective eyewear).

Special Considerations

Never pump corrosive or abrasive liquids as these will cause rapid wear or deterioration of body, rotor, shaft, and seals in the pump. The pump should be used only with liquids compatible with pump component materials. Never exceed maximum specified rpm and pressure. Never run the pump dry. Failure to follow this warning will void the product warranty.

*We do not accept returns on equipment, all sales are final. We do this to ensure that the products we send out are brand new, never opened, and fully operational for our customers to ensure the packages are covered by their respected manufacturer's warranties.