• Call (800) 479-6583
  • Mon-Fri 8am-5pm
  • |
  • Sat 9am-5pm

Fuse Insecticide Termiticide

Free Shipping on All Orders

Fuse Insecticide/Termiticide contains a combination of Imidacloprid and Fipronil to make it the best chemical to treat for termites and ants. Fuse Insecticide uses combination chemistry to control termites and other perimeter pests.

Target Pests

Fuse Termiticide/Insecticide is used for the control of ants (acrobat argentine big-headed caribbean crazy carpenter crazy odorous pavement and thief) asian lady beetles darkling beetles cellar spiders boxelder bugs pill bugs cluster flies european earwigs house crickets millipedes silverfish and termites.

For Use In

Fuse Termiticide/Insecticide is for use on outside surfaces of listed structures wall voids outside perimeter of structures and building construction.


For the use of Fuse Termiticide/Insecticide as a termite barrier mix at the rate of 27.5 oz per 100 gallons of water to reach a 0.067% dilution rate or at 55 oz per 100 gallons to reach a 0.13% dilution rate and be sure to follow label directions in order to ensure a proper application.

For the use of Fuse Termiticide/Insecticide as a perimeter pest treatment mix at the rate of 0.3 to 0.6 oz per gallon of water and apply as directed.


Apply 0.067% to 0.13% of finished FUSE Termiticide/Insecticide dilution as a low-pressure spray to the exterior of the structure where listed pests enter, trail around the structure or where they crawl and hide. Treat using a low-pressure coarse banded surface spray up to 18 inches in width around doors, windows, vents, pipes, foundation cracks, drilled holes or around any exterior opening where listed pests could enter the structure. Make sure to treat the joint where exterior siding (wood, vinyl, aluminum or other similar materials) meets the cement, brick or block foundation. Treat anywhere electrical, cable or telephone wires enter the house. This treatment must be made as a general surface spray, crack and crevice spray, or a wall void application.

Coverage Area

If used according to the label each bottle of Fuse Termiticide/Insecticide will treat 240 linear feet.

Time to Kill

Fuse Termiticide/Insecticide will begin killing insects immediately and provide years of insect protection when applied properly

Country of Manufacture

United States

Mix Rate

Follow this procedure for mixing Fuse Insecticide:

1. Fill tank to 1/3 full. 2. If using large sprayer, start pump to begin bypass agitation and place end of treating tool in tank to allow circulation through hose. 3. Add appropriate amount of FUSE Termiticide/Insecticide. 4. Add remaining amount of water.

Active Ingredient

Imadicloprid 21.4%, Fipronil 6.6%

Fuse Insecticide Termiticide

Product Q & A

Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
Can use on yards?
A shopper on Feb 27, 2018
BEST ANSWER: Application to Perimeter of Listed Structures
Apply 0.067% to 0.13% of finished Fuse dilution as a low pressure, coarse, general surface spray along
the foundation exterior perimeter. The applications may be made in a narrow band of 1 foot wide out by 1
foot wide up from where the ground meets the foundation or in a wide band of 2 feet wide out by 2 feet
wide up from where the ground meets the foundation. Refer to the Application Table for Perimeter
Treatments for the maximum number of applications permitted each year based on concentration and
band width.

I can be used outside as a perimeter spray, but not to apply to lawns.

Customer Reviews

There are no reviews for this item. Write Review

Contact Us