D-50 Hose Unit 48" (22030100) by B&G Equipment Company is specifically sold for use as a replacement part for B&G sprayers. The hose is an important part of the sprayer as it helps to transport the fluid from the tank to the sprayer tip so it can be distributed and sprayer properly. Hoses experience wear and tear over time and should be replaced periodically to prevent leaks.

Tools Needed

To use this part, you will need the appropriate B&G Sprayer to replace the part on and possibly a pair of pliers or a crescent wrench if the parts are tightly secured.

How to Use

• Step 1: Using the wrench, undo the old sprayer hose from both the tank and from the spray wand.
• Step 2: Attach the new hose with the female side going to the fitting on the tank and the male side going to the spray valve.
• Step 3: Tighten (making sure not to overtighten) and test it out and your Sprayer is ready to rock.

Where to Use

The spray hose is meant to be used only for replacement on a B&G handpump sprayer such as the N124 and similar models. There are other models it can also fit.

When to Use

Replace the spray hose when it has been damaged or you are experiencing leaks or any other reduction in spray quality. How often this part is changed depends on how often you use the sprayer. If it is heavily used, the part wears and tears quicker. Typically at minimum we suggest changing it out annually.

Safety Information

Be sure to wear gloves when handling the B&G sprayer parts, as there may be residue from chemicals or buildup on the sprayer parts. Be sure to properly drain and clean the sprayer parts before performing maintenance. Keep the hose out of reach of pets and children.

Special Considerations

Along with the spraying hose, check to see if any other small parts on the B&G Sprayer need replacing. Set a maintenance schedule for your sprayer and change out all the parts in one shot to save time so your B&G sprayer can be ready to use.