B&G 360 Degree Tip Model 451 - 2 GPM 5/8" is a termite application tip made by B&G Equipment and can be used on the Versatool Sub Slab Termiticide application tool to treat termites.

This tip can apply liquid termiticide at a rate of 2 gallons per minute and shoots liquid in a straight line as well as 360 degrees from all sides.

The B&G 360 Degree Tip Model 454 is made with durable stainless steel and is ideal when applying termiticides under concrete slabs or in soils outside building perimeters using a 5/8" pipe. If you're looking to conduct a termite barrier treatment and have to drill holes into slab, the this tip is essential.

Tools Needed

To use the B&G 360 Degree Tip Model 454 - 2 GPM 5/8" you will need either a Versatool Sub Slab Injector termite treatment tool. You may also need a wrench to help you tighten the tips onto your termite rods.

How to Use

• Step 1: Following manual directions, attach the B&G 360 Degree Tip Model 454 to your Versatool Sub-Slab Injector rod using a 5/8 inch pipe. Tighten it using a wrench if you need to.
• Step 2: Reassemble the Sub Slab Injector and add termiticide to the tool to prepare for the injection application by drilling a hole in the slab or suspended floor that needs treatment.
• Step 3: Apply the termiticide to the void area with the help of the tip for a nice flow of liquid beneath a concrete slab..

Where to Use

The B&G 360 Degree Tip Model 454 is used in the B&G Sub Slab Injector termite tool. It is attached to the end of the termite rod to get deep penetration in voids under concrete slab or in soils around the outside perimeters of building.

When to Use

Use the B&G 360 Degree Tip Model 454 when you are trenching or treating for termites and need to apply termiticide to a void that may be hard to treat normally and would require a termite rod.

Safety Information

The B&G 360 Degree Tip Model 454 tip is safe to install when done so according to manual directions. Please have on the proper PPE when treating for termites. Keep the tip out of reach of pets and children as the tip is very small and can be accidentally swallowed

Special Considerations

Aside from the B&G 360 Degree Tip Model 454, there is also a 180 degree fan tip available and tips that spray in a straight, non-directional pattern (tip #457). Flush the valve, application pipe and tips with clean water regularly. Termiticide residue can reduce the operation and accuracy of valves and tips.