Pelsis Infiniti LED Strip, manufactured by Pelsis, is a flexible LED UV strip that entices pests toward the Pelsis Infiniti Fly Light glueboards to efficiently increase the capture rate within various indoor sites.

With superb flexibility, this product easily goes behind glueboards to emit a 368NM wavelength light to attract flies toward the adhesive. The ultra slim design of this product saves valuable storage space and fits perfectly in the unit.

Pelsis Infiniti LED Strip is a high efficiency UV LED strip that emit a long-term UV output of 3 years for continual indoor pest control.

Tools Needed

Pelsis Infiniti LED Strip comes ready to use with no other application tools necessary.

How to Use

To Remove Old LED Strip

• Step 1: Ensure the Pelsis Infiniti Fly Lights are disconnected from the power source.
• Step 2: Open the front guard and remove the glueboard. Face the unit and remove the old LED strip by sliding it to the right until the strip connector on the left is clear of the housing. Use the protrusion on the top of the strip to help push the LED strip.
• Step 3: Slide the LED strip up until it is clear of the spring clips. Use the protrusion on the bottom of the strip to assist.
• Step 4: Lift the strip away from the unit.

To Install a New LED Strip

• Step 1: Face the unit and hold the new LED strip with the LEDs facing you and with the connector on your left. Place the new LED strip so that it is just above the spring clips and flat against the back face of the unit.
• Step 2: Slide the LED strip down and under the spring clips - until the lower edge of the strip stops against the body of the unit. Slide the LED strip left into the housing until the LED strip is connected. Check that the LED strips are fitted correctly by closing the front guard and reconnecting the mains power.
• Step 3: If the LEDs do not light up, disconnect the power, open the front guard and check that the LED strips are fully engaged. After this the glueboard can be inserted.

Where to Use

Pelsis Infiniti LED Strip can only be used with Pelsis Infiniti Fly Light.

When to Use

Replace the Pelsis Infiniti LED Strip once every 3 years.

Safety Information

Pelsis Infiniti LED Strip is safe to use around children and pets when installed according to the product manual instructions. Always wear the proper personal protective equipment (PPE) when using this product.

Keep out of reach of children and pets.

Special Considerations

Pelsis Infiniti LED Strip replacement should only be carried out by service professionals only.