• Call (800) 479-6583
  • Mon-Fri 8am-5pm
  • |
  • Sat 9am-5pm


Free Shipping on All Orders

This pressure gauge replacement kit includes a 2" pressure gauge. Mistaway has updated this part and it will no longer include an adapter ring.

Target Pests


For Use In

Mistaway Mosquito Misting Systems


Replacement MistAway System Pressure Gauge. This is a replacement pressure gauge kit. If your gauge does not read "0" when the system is off and depressurized, use this gauge to repair your system. Set your MistAway system pressure to 250 psi for optimum results. Setting your system pressure over 250 psi will void your system's warranty and pre-maturely wear out the system pump. Part Number 11095

How To

Replacing the pressure gauge for your Mistaway Mosquito Misting system is simple to do and doesn't take very long with the right tools (a 15mm wrench and pliers)

1. Remove bottle. Reposition controller and shroud.

2. Remove existing pressure gauge

A. Using a zip tie, Cut zip tie securing flexible tubing to coupler. Put on latex gloves and remove tubing. Allow concentrate in tubing to drain onto paper towel.

B. Remove 1/4" nylon tubing from fitting on pressure gauge and remove shroud from unit.

C. Using channel locks or crescent wrench and 15 mm wrench, remove straight female connector

D. Using 5/16" nut driver to remove nuts securing gauge to bracket, and remove the gauge from shroud.

To Install Replacement Gauge:

A. Wrap teflon tape around threads on gauge.

B. If the diameter of the failed gauge (and the hole it was mounted in) is the same size as the new gauge, proceed to step 3D. if not, you'll need to use the adapter rings.

C. Slide one of the adapter rings over the gauge, then insert the gauge into the hole, so that the ring is between the gauge and the top side of the shroud. Slide the other adapter ring over the gauge, sandwiching the gauge between the two rings.

D. Position the bracket on the back of the gauge and then tighten the straight female connector to the gauge.

E. Ensure the gauge is oriented correctly on the top side of the shroud, then tighten the nuts securing the gauge to the shroud.

F. Place shroud with new gauge on left side of unit and reconnect 1/4" nylon tubing to gauge. Make sure it is secure in the fitting.

G. Reconnect flexible tubing that feeds dosing pump to hose barb on coupler and secure with zip tie.


Product Q & A

Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 1 question Browse 1 question and 1 answer
This will replace the pressure gauge that is in on my misting system?
Bruce on May 24, 2017
BEST ANSWER: Yes if it is a Mistaway unit it will fit into the system.

Customer Reviews

5.0 / 5.0
1 Review
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
I received it quickly, enjoyed the friendly knowledgeable customer service reps.
May 24, 2017

Contact Us