Description
Restaurants and other food preparation facilities
often experience sanitation problems associated
with the buildup of kitchen grease (organic waste) on
floors, in drains, and under heavy equipment. These
problems include fruit and drain fly infestations,
slippery floor surfaces, foul odors, and clogged
(slow) drains. Mopping with standard floor cleaning
products, or hosing/power washing with water
only, does not remove grease and organic waste
– it only breaks it up pushing it into drains and under
equipment where it accumulates.
New formula BioMop™ is a state-of-the-art
floor cleaner combined with a highly concentrated
biological degrader. The biological component
consists of Bacillus-family microorganisms including
MGD™ (Microbial Grease Degrader), a patent-pending strain that breaks down long chain fatty
acids – the primary component of problem grease
deposits. BioMop™ quickly penetrates porous floor
surfaces and digests grease that accumulates over
time. It also inhibits foul odors caused by rancid or
anaerobic environments. BioMop™ cleans the floor
and removes organic waste – all in one step.
BioMop™ can be applied by mopping or hosing.
For mopping add 2 oz. to 1-gallon water and mop in
the usual manner (treat drains by pouring the unused
mop water into each drain). To apply by hosing
use the BioMop Hose End Sprayer (for smaller
facilities) or the wall-mounted BioMop Application
System (for larger facilities). Both systems inject
BioMop™ into the water stream at pre-set dilution
ratios. Visit www.bio-systems.com for additional
product information.
Product Characteristics
Bacteria Count: >200 Billion/gallon
Bacteria Type: Blend of Bacillus Spores
Salmonella/Shigella: Negative
Appearance: Blue (colorless after dilution)
Fragrance: No fragrance added
Stability: 2 years+ at 35°F to 95°F
pH Value: 7.5 - 8.0
Storage and Handling
Store in cool, dry place. Avoid eye contact.
Wash hands thoroughly with warm, soapy water
after contact.
Availability
• 128 FL. Oz. (1 Gallon) - 3.79L - 4 Bottles/Case
• 5 Gallon (18.95L) Pails
• 55 Gallon Drums
Additional Information
www.bio-systems.com
Contact Your Local BioMop Distributor
New Formula
With MGD
American Bio-Systems
(888) 371-3353 • Fax (888) 708-5353
customersupport@bio-systems.com • www.bio-systems.com
Bacteria Formulation for General Cleaning
and Removal of Organic Material
6 One-step procedure for general floor
cleaning and removal of grease and
organic waste from hard-to-access
corners, cracks and crevices
6 Removes grease and organic waste
from drain lines and drain areas
6 Cleans grout and penetrates porous
floor surfaces
6 Safe for all types of plumbing
6 Can be applied by mopping or hosing.
Safe for all washable surfaces
6 Biodegradable, non-toxic, non-caustic
and non-pathogenic
6 Salmonella and Shigella free
Section 1 - Product
Product Name Manufacturer/Distributor Emergency Telephone Number
BioMop American Bio-Systems, Inc.
Phone: (888) 371-3353
Inquiry: American Bio-Systems, Inc.
Emergency: (888) 371-3353
Outside USA: (888) 371-3353
Section 2 - Ingredients
INGREDIENT CAS NO. TLV (ACGIH)
Alkoxylated Linear Alcohol 68987-81-5 NA
Alkyl Sulfate 2235-54-3 NA
Dodecylbenzenesulfonic Acid 27176-87-0 NA
Fragrance 5989-27-5 NA
Viable Bacterial Cultures NA NA
Water 7732-18-5 NA
Section 3 - Physical/Chemical Characteristics
Specific Gravity 1.0 Boiling Point 100 Deg. C
Vapor Pressure (mm Hg at 20C) =Water Melting Point N/A Deg. C
Vapor Density (Air=1) =Water Evaporation Rate 1 (Water=1)
Solubility in Water 99% pH 7.5-8.0
Appearance Blue (colorless
after dilution) Odor No fragrance added
HMIS rating (0-4): Health = 1, Fire = 0, Reactivity = 0
Section 4 - Fire and Explosion Hazard Data
Flash Point (Deg C)/Method Used NA
Autoignition Temp. NA
Flammable Limits NA
Extinguishing Media Water spray, carbon dioxide, dry chemical power
Special Fire Fighting Procedures None
Unusual Fire and Explosion Hazards NA
Section 5 - Reactivity Data
Stability Stable under normal conditions
Incompatibility (Materials to Avoid) Strong acids or alkali compounds may inactivate biological
cultures
Hazardous Decompositions Products None
Hazardous Polymerization Will not occur
Material Safety Data Sheet
Section 6 - Health Hazard Assessment
Ingestion Ingestion may result in abdominal pain, nausea and vomiting.
Eye Contact This material may cause eye irritation.
Skin Contact Contact may cause irritation.
Skin Absorption Systemically toxic concentrations will probably not be absorbed
through the skin in man.
Inhalation None known.
Other Effects of Overexposure None known.
First Aid Procedures
Skin: Remove contaminated clothing and footwear. Wash material off the skin with soap and water. Wash
clothing and footwear before reuse.
Eyes: Immediately flush with water for at least 15 minutes and have eyes examined and treated by medical
personnel.
Ingestion: Induce vomiting only if advised by physician or poison control center.
Section 7 - Spill or Leak Procedures
Steps to be taken in case material is released or spilled: Where possible, flush down drain to waste treatment
sewer; otherwise, on small spills, use chemical absorbent and sweep up. For large spills, contain and collect
for reuse or disposal.
Disposal method: Disposal of this product or its residues must be in accordance with all local, state and Fed-eral requirements.
Section 8 - Special Protection Information
TLV or suggested control value: No TLV assigned to this mixture. Control of exposure to below the TLV for the
ingredients (see Section 2) will be sufficient. Minimize exposure in accordance with good hygiene practice. To
maintain shelf life, avoid prolonged exposure to high or low temperatures and humidity. Avoid temps above
110F and keep from freezing.
Ventilation Normal room ventilation.
Respiratory protection None required for recommended use. Avoid creating aerosols in
poorly ventilated areas.
Protective clothing NA
Inhalation None known.
Eye protection Safety glasses.
Section 9 - Special Precautions or Other Comments
Precautions to be taken in handling or storing: Prevent skin and eye contact. Wash hands thoroughly with
soap and water after use. Avoid contact with eyes.
Revised 5/30/2001
Material Safety Data Sheet
DESCRIPTION
New formula BioMop™ is a state-of-the-art clean-er combined with a highly concentrated biological
degrader. The biological component consists of
Bacillus-family microorganisms including MGD*
(Microbial Grease Degrader). MGD is the most
effective degrader of complex grease molecules
(kitchen grease) ever produced. It will safely and
quickly digest grease and other organic material
from floors, hard-to-access corners, and drains.
New formula BioMop™ cleans the floor and re-moves organic material – all in one step.
* Patent Pending
KEEP OUT OF THE REACH OF CHILDREN
PRECAUTIONARY STATEMENTS
HAZARDS TO HUMANS &
DOMESTIC ANIMALS
CAUTION
HARMFUL IF SWALLOWED: Wash thoroughly
with soap and water after handling.
HARMFUL IF INHALED: Avoid breathing spray
mist. Remove contaminated clothing and wash
clothing before reuse.
CAUSES MODERATE EYE IRRITATION: Avoid
contact with eyes or clothing. Wash thoroughly with
soap and water after handling.
FIRST AID
IF SWALLOWED: Call a physician or Poison Con-trol Center.
IF INHALED: Remove victim to fresh air. If not
breathing, give artificial respiration, preferably
mouth-to-mouth. Get medical attention.
IF IN EYES: Flush eyes with plenty of water. Call a
physician if irritation persists.
INSTRUCTIONS FOR USE
FOR MOPPING APPLICATION
1) Add 4 ounces of BioMop™ to 2 gallons of
water.
2) Mop floor in normal manner insuring to mop in
all corners, cracks, crevices and under equip-
ment.
3) After mopping is completed, pour remaining
mop water into each drain in equal portions.
4) If problem areas exist that cannot be reached
during mopping, pour undiluted BioMop™ into
a spray bottle and spray problem areas until
wet.
FOR HOSING AND
POWER WASHING APPLICATION
1) Pre-rinse floor with hose or power washer with
water-only in the usual manner.
2) Using either the BioMop Hose End Sprayer
(for smaller facilities) or the BioMop Appli-
cation System (for larger facilities), apply
BioMop™ according to the application sys
tem’s instructions.
3) Thoroughly rinse all floor areas with BioMop™
including under equipment, in cracks and
crevices, and around all drain areas.
4) If necessary, squeegee excess water into
floor drains.
IMPORTANT
1) DO NOT mix BioMop™ with other floor
cleaning products, especially products
with a high pH value or containing
chlorine bleach.
2) DO NOT rinse with water-only or apply
disinfectants to floor area after BioMop™
application.
American Bio-Systems
Information Call (888) 371-3353
Made in U.S.A.
Bacteria Formulation for General Cleaning
and Removal of Organic Material
